![\"\"](\"https:\/\/www.petestack.com\/blog\/wp-content\/uploads\/2019-01-13battery-1.jpg\")
<\/a> ![\"\"](\"https:\/\/www.petestack.com\/blog\/wp-content\/uploads\/2019-01-13battery-2.jpg\")
<\/a><\/p>\nOther ongoing projects from the first week of January that you don’t see here include stripping the pilot berth structures of flaking paint (something I’m only doing outside when I’ve got both daylight and mild, dry conditions) and engine alignment (done by Twig). But I’ve got some work done on the tiller (which we’d removed to get the engine through the pushpit) this weekend, making a wee repair where the exposed end grain was suffering. Think I might finish that by epoxy-coating where I’ve chamfered the corners and a bit down the sides, but not till I’ve got some mixed up for another job:<\/p>\n
The restored\/improved chart table is all done apart from some new catches to hold it shut and a folding leg for the non-bulkhead end. While I was tempted by sprung ball catches, I’m going to fit magnetic ones because the dimensions suit better and and they’ll be much easier to fit. It used to have two horrid wee hooks on the outside, but I’m fitting catches to the inside front edge (there’s plenty of room for the charts):<\/p>\n Here it is in the stowed\/upright position. The teak handle (which I found in a box of bits stashed in my loft) replaces an ugly alloy one. There’s also a cushion to go back where you see the slightly lighter wood and two screw holes:<\/p>\n And here it is as you’d use it (well, not on the floor!). The fiddles (edges) to stop things sliding off are new; it doesn’t need one to the right because there’s a bulkhead there, and the left ones have been left partial to fold up over the nav. station shelves:<\/p>\n<\/a> <\/a><\/p>\n<\/a> <\/a><\/p>\n<\/a> <\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n